Removal and replacement procedures
Maintenance and Service Guide 4–41
Battery eject arm
Before removing the battery eject arm, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see “Battery” on page 4-7).
5. Remove the following components:
a. Accessory cover (see “Mass storage device” on page 4-9)
b. Keyboard (see “Keyboard” on page 4-23)
c. Button board and cable (see “Button board and cable” on page 4-26)
d. Top cover (see “Top cover” on page 4-28)
e. System board (see “System board” on page 4-33)
Remove the battery eject arm:
1. Turn the base enclosure upside down, with the front toward you.
2. Use a flat-bladed screw driver 1 or similar tool to release the battery eject latch from the base enclosure.
3. Remove the the battery eject latch 2.
Description Spare part number
Latch Kit (includes battery eject arm, latch, and spring) 581090-001
To Next Page
Loading...
