g.
Keyboard (see
Keyboard on page 88)
h. Base enclosure (see
Base enclosure on page 93)
i.
System board (see
System board on page 106)
j. Heat sink (see
Heat sink on page 111)
Remove the processor:
1. Use a flat-bladed screw driver (1) to turn the processor locking screw one-half turn
counterclockwise, until you hear a click.
2.
Lift the processor (2) straight up, and remove it.
NOTE: The gold triangle (3) on the processor must be aligned with the triangle icon (4)
embossed on the processor socket when you install the processor.
Reverse this procedure to install the processor.
116 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
