HP ProCurve 3500 - 2 Installing the Switch; Included Parts and Preparation

2-1
Installing the Switch
2
Installing the Switch
The HP ProCurve 3500, 3500yl and 6200yl switches come with an accessory
kit that includes the brackets for mounting the switch in a standard 19-inch
telco rack, in an equipment cabinet, and with rubber feet that can be attached
so the switch can be securely located on a horizontal surface. The brackets
are designed to allow mounting the switch in a variety of locations and
orientations. For other mounting options contact your local ProCurve
authorized network reseller or HP ProCurve representative. This chapter
shows how to install the switch.
Caution If the switch is to be shipped in a rack, be sure to use only an HP 10K rack.
Mount the switch using rail kit, HP ProCurve 1U RK MT SWITCH 10K ALL,
part number 356578-B21 and shelf kit AB469A, HP rx 16/26 Factory
Rackmount Shelf Kit. Both kits must be used. Otherwise you will void the
warranty.
Included Parts
The HP ProCurve 3500, 3500yl and 6200yl switches have the following
components shipped with them:
■ HP ProCurve 3500, 3500yl and 6200yl switches Quick Setup Guide
■ Read Me First
■ Switch Specific Safety and Regulatory sheet
■ Customer Support/Warranty booklet
■ General Safety and Regulatory booklet
■ Console cable