2-14
Installing the Switch
Installation Procedures
Installing the mini-GBICs or SFP/SFP+ transceivers:
Hold the mini-GBIC by its sides and gently insert it into either of the slots on
the switch until the mini-GBIC clicks into place. When a mini-GBIC or SFP/
SFP+ transceiver is inserted the switch authenticates it. This can take 1-3
seconds, with the worst case being 5 seconds. If the mini-GBIC or SFP/SFP+
transceiver is removed before the authentication completes a self test failure
will be reported.
WARNING The HP ProCurve mini-GBICs and the SFP/SFP+ transceivers are Class
1 laser devices. Avoid direct eye exposure to the beam coming from
the transmit port.
Figure 2-12. Installing a mini-GBIC.
Removing the mini-GBICs:
Note You should disconnect the network cable from the mini-GBIC before removing
it from the switch.
Depending on when you purchased your HP ProCurve mini-GBIC, it may have
either of three different release mechanisms: a plastic tab on the bottom of
the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail.
To remove the mini-GBICs that have the plastic tab or plastic collar, push the
tab or collar toward the switch until you see the mini-GBIC release from the
switch (you can see it move outward slightly), and then pull it from the slot.
To remove the mini-GBICs that have the wire bail, lower the bail until it is
approximately horizontal, and then using the bail, pull the mini-GBIC from the
slot.
To Next Page
Loading...
