2-20
Installing the Switch
Installation Procedures
630 RPS/EPS
The 630 RPS/EPS can provide backup power support for one HP ProCurve
switch. In Figure 3-14, one HP ProCurve 3500yl-48G-PoE+ switch is connected
to the RPS port on a 630 RPS/EPS.
Figure 2-17. Connecting the 630 RPS to a switch
The 630 RPS/EPS is designed to provide primary or backup PoE+ power to
one HP ProCurve PoE+ switch. In the following illustration, one HP ProCurve
3500yl-48G-PoE+ switch is being supplied with external PoE+ power from a
630 RPS/EPS. The switch provides PoE+ power to Ethernet devices connected
to the ports.
Figure 2-18. Connecting the 630 EPS to a switch
■ For further information regarding the external power supply PoE/PoE+
capabilities, see the following manuals:
• HP ProCurve Power over Ethernet (PoE/PoE+) Planning and
Implementation Guide
• HP ProCurve 620 Redundant and External Power Supply
Installation and Getting Started Guide
• HP ProCurve 630 Redundant and/or External Power Supply
Installation and Getting Started Guide
These manuals are on the HP ProCurve Web site at www.hp.com/go/procurve/
manuals.
To Next Page
Loading...
