Removal and replacement procedures 60
4.
Close the processor retaining latch and the processor socket retaining bracket.
5. Clean the old thermal grease from heatsink and the top of the processor with the alcohol swab.
Allow the alcohol to evaporate before continuing.
6. Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
7. Install the heatsink ("Heatsink" on page 47).
IMPORTANT: To ensure proper cooling, be sure the processor air baffle is installed at all times
(if applicable).
8. Install all components removed from the failed system board.
To Next Page
Loading...
