NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE:
Factory Integrated Models must start with a CTO Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Configuration (choose one of the following configurable models)
HP Models
HP ProLiant DL360e Gen8 8 SFF Configure-to-order Server
661189-B21
NOTE:
New options are available for Rack Rail Kits; these options are no longer
standard on-board with this Model Part Number. Please see HP Rack Options below for
optional required options.
I n c l u d e s:
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 8-Small Form Factor
12 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
HP Ethernet 1Gb 4-port 366i Adapter
HP Dynamic Smart Array B120i Controller (Cache connection for 512MB FBWC options)
I/O slots - 2 Slots come standard:
Slot 1 - Full-Height/Half-Length (250mm) x 16 PCIe 3.0
Slot 2 - Low Profile x 8 PCIe 2.0
System Fans - 4 (4 additional fans included with second processor kit)
USB - 4 Rear, 2 Front, 1 Internal
1 Internal SD slot
HP iLO Management Engine (standard)
HP ProLiant DL360e Gen8 4 LFF Configure-to-order Server
661190-B21
NOTE:
New options are available for Rack Rail Kits; these options are no longer
standard on-board with this Model Part Number. Please see HP Rack Options below for
optional required options.
I n c l u d e s:
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 4-Large Form Factor
12 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
HP Ethernet 1Gb 4-port 366i Adapter
HP Dynamic Smart Array B120i Controller (Cache connection for 512MB FBWC options)
I/O slots - 2 Slots come standard:
Slot 1 - Full-Height/Half-Length (250mm) x 16 PCIe 3.0
Slot 2 - Low Profile x 8 PCIe 2.0
System Fans - 4 (4 additional fans included with second processor)
USB - 4 Rear, 2 Front, 1 Internal
QuickSpecs
HP ProLiant DL360e Generation 8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14327 North America — Version 36 — January 22, 2014
Page 28
To Next Page
Loading...
Need help?
General
