234 Reference and Troubleshooting Guide
IMPORTANT: This guide provides information for multiple servers.
Some information may not apply to the server you are troubleshooting.
Refer to the server documentation for information on procedures,
hardware options, software tools, and operating systems supported by
the server.
NOTE: The error messages in this section may be worded slightly
different than as displayed by the server.
A CPU Power Module (System Board, Socket X)...
...A CPU Power Module (Slot X, Socket Y) Failed
Event Type: Power module failure
Action: Replace the power module. In the case of an embedded power module,
replace the system board.
ASR Lockup Detected: Cause
Event Type: System lockup
Action: Examine the IML ("Integrated Management Log" on page 101
) to
determine the cause of the lockup, and then refer to the HP ROM-Based Setup
Utility User Guide, on the server Documentation CD or at the SmartStart website
(http://h18013.www1.hp.com/products/servers/management/smartstart
), for more
information.
Automatic Operating System Shutdown Initiated Due to Fan Failure
Event Type: Fan failure
Action: Replace the fan.
Automatic Operating System Shutdown Initiated Due to Overheat Condition...
...Fatal Exception (Number X, Cause)
Event Type: Overheating condition
Action: Check fans. Also, be sure the server is properly ventilated and the room
temperature is set within the required range.
To Next Page
Loading...
