60 Reference and Troubleshooting Guide
Installing a Tape Drive Option
1. Power down the server ("Powering Down the Server" on page 21).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 22
).
3. Remove the front bezel door, if necessary ("Removing Front Tower Bezel"
on page 23
).
4. Remove the access panel ("Removing Access Panel" on page 23
).
5. Install the guide screws ("Identifying Guide Screws" on page 55
), if
applicable.
6. Configure the device by setting the SCSI ID. The SCSI ID on each device
must be manually set to a unique value. Refer to the documentation provided
with the device for instructions on setting the SCSI ID.
7. Install the drive into the drive bay until it clicks into place.
IMPORTANT: HP recommends installing the tape drive on a separate
SCSI cable to avoid a decrease in performance on other SCSI devices.
To Next Page
Loading...
