Server Cabling 85
Installing an Internal-to-External SCSI Connector
If you are not using one or both SCSI channels (primary or secondary) internally
or you install a SCSI or SmartArray option card, you may install an internal-to-
external SCSI connector in the SCSI knockout locations on the rear of the
chassis.
For installation instructions, refer to the VHDCI or HD68 SCSI Cable ("VHDCI
or HD68 SCSI Cable Option" on page 68
) section in this guide.
Cabling SmartArray or other RAID Controller
Many configurations are possible when SCSI controllers are added. This section
outlines the procedure for connecting internal hard drives to a SCSI controller
option or a SmartArray Controller and assumes that the controller option or
SmartArray Controller is already installed.
If hard drives and the SCSI or SmartArray Controller are not already installed,
follow the steps in the sections "Installing Hard Drives ("Hard Drive Options" on
page 50
)" and "Installing an Expansion Board (on page 66)".
To cable a Smart Array or other RAID controller:
To Next Page
Loading...
