HP ProLiant ML350 Generation 5 - Front Panel and Access Components

Removal and replacement procedures 27
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
4. After performing the installation or maintenance procedure, press the rail-release latches and slide the
server back into the rack.
Remove the server from the rack
To remove the server from an HP, telco, or third-party rack:
1. Power down the server (on page 26).
2. Disconnect the cabling.
3. Extend the server from the rack (on page 26). Reverse the server installation steps in the documentation
that ships with the rack-mounting option.
4. Remove the server from the rack.
5. Place the server on a sturdy, level surface.
Front bezel
This server has a removable bezel that must be unlocked and opened before accessing the front panel
components. The bezel should be kept closed during normal server operations.
Use the key provided with the server to unlock the bezel with a clockwise turn.
If necessary, remove the bezel.
CAUTION: To avoid breaking the bezel, remove the bezel before placing the server on its side.