HP ProLiant ML350 Generation 5 - System Board Replacement

Removal and replacement procedures 55
4.
Remove the battery.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through RBSU.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
System board
To remove the component:
1. Power down the server (on page 26).
2. Do one of the following:
o Unlock and remove the bezel ("Front bezel" on page 27).
o Extend the server from the rack (on page 26).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the air baffle ("Air baffle" on page 35).
5. Remove the system fans (on page 35).
6. Remove all expansion boards ("Expansion board" on page 37).
7. Remove the cache module ("Battery-backed write cache module" on page 39).
8. Remove all FBDIMMs ("FBDIMM" on page 52).
9. Remove the PPM.
10. Remove the heatsink ("Heatsink" on page 44).
CAUTION: To avoid damage to the processor:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.