Hardware options installation 84
10.
Using the system board tray handles, slide the tray forward and remove the system board.
11. Connect the 10-pin connector on the PCIe power cable to the power supply backplane. Be sure to
thread the cable through the center wall.
12. Install the system board.
13. Tighten the thumbscrews.
14. Connect all cables to the system board.
15. Install all fans.
16. Install all DIMM baffles.
17. Install the large redundant fan air baffle, if removed.
18. Install all expansion boards.
19. Connect the PCIe power cable to an installed PCIe expansion board, as needed.
To Next Page
Loading...
