Hardware options installation 88
In addition to the supplied items, you may need:
• T-10 Torx screwdriver
• T-15 Torx screwdriver
To convert a tower server to a rack server:
1. Power down the server (on page 24).
2. Disconnect all rear panel cabling ("Rear panel components" on page 9).
3. Remove the tower bezel ("Open or remove the tower bezel" on page 25).
4. Remove the feet.
5. Remove both tower configuration panels:
a. Using the T-10 Torx screwdriver, remove the front panel screws.
b. Unhook the tower configuration panels from the chassis.
To Next Page
Loading...
