Hardware options installation 102
8.
Install the TPM board. Press down on the connector to seat the board ("System board components" on
page 11).
9. Install the TPM security rivet by pressing the rivet firmly into the system board.
10. If removed, install the PCI card in slot 6.
11. Install the PCI air baffle (on page 29), if removed.
12. Install the access panel (on page 26).
13. Do one of the following:
o For tower models, return the server to an upright position.
o For rack models, slide the server back into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
17. Do one of the following:
To Next Page
Loading...
