Operations 36
7.
Remove the DVD drive.
Remove a component drive cage blank
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel.
o For rack models, do the following:
i. If installed, remove the security bezel (on page 24).
ii. Remove the access panel. ("Remove the access panel" on page 25)
iii. Release thumbscrews and remove the rack bezel.
2. Remove the component drive cage blank.
WARNING:
To reduce the risk of personal injury from an electrical hazard, do not remove more
than one drive cage at a time.
To Next Page
Loading...
