Hardware options installation 88
3.
Install the two capacitor holders on top of the redundant power supply assembly.
4. Route and connect the redundant power supply cables to the system board.
Item Cables and connectors
1
Graphic power cable connector
2
2x13 RPS control cable connector
3
2x12 pin power cable connector
4
2x4 pin processor 1 power cable connector
5
2 pin power good cable connector
6
2x4 pin processor 2 power cable connector
7
2x5 pin drive power cable connector
8
Optical drive SATA cable connector
To Next Page
Loading...
