Hardware options installation 94
17.
Install a drive blank into any unused drive bays.
18. Install any PCI cards removed.
19. Install the system air baffle (on page 30).
20. Install the PCI air baffle (on page 29), if removed.
21. For rack models, install the rack bezel.
22. Install the access panel (on page 26).
23. Do one of the following:
o For tower models, return the server to an upright position.
o For rack models, slide the server back into the rack.
24. Install the rack bezel (on page 25).
25. Power up the server (on page 22).
26. Do one of the following:
o For tower models, install the bezel ("Install the tower bezel" on page 23).
o For rack models, if removed, install the security bezel ("Security bezel option" on page 47).
Tower-to-rack conversion option
1. Back up the server data, and then record configuration information.
2. Close all applications, and then using the normal shutdown sequence, shut down the operating system.
3. Remove the bezel:
a. Unlock the tower bezel and then open the bezel door completely.
b. Slide the bezel up, removing it completely from the chassis.
To Next Page
Loading...
