HP ProLiant ML350p - Page 29

Operations 29
4.
For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel (on page 22).
5. For rack models, do the following:
a. Extend the server from the rack (on page 23).
b. Remove the access panel (on page 22).
c. Release thumbscrews and remove the rack bezel.
6. Remove the fan cage (on page 26).
7. Disconnect and remove the optical drive power and data cables.
8. Remove the optical drive.
Remove the component drive cage blank
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 20).
o For rack models, do the following:
a. If installed, remove the security bezel (on page 20).
b. Remove the access panel. ("Remove the access panel" on page 22)
c. Release thumbscrews and remove the rack bezel.
2. Remove the component drive cage blank.
WARNING:
To reduce the risk of personal injury from an electrical hazard, do not remove more
than one drive cage at a time.