Hardware options installation 66
2.
Power down the server (on page 19).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 23).
5. Remove the access panel (on page 22).
6. Remove the air baffle (on page 24).
7. Open the PCIe retainer latch.
8. Do one of the following:
a. If you are installing a single-width expansion card, remove one PCIe blank.
To Next Page
Loading...
