Hardware options installation 82
13.
Connect the power cable to the system board connector appropriate for your configuration.
14. Install the fan cage.
15. Install the air baffle.
16. For tower models, do the following:
a. Install the access panel (on page 23).
b. Return the server to an upright position.
17. For rack models, do the following:
a. Install the rack bezel (on page 22).
b. Install the access panel (on page 23).
c. Slide the server back into the rack.
18. Connect each power cord to the server.
19. Connect each power cord to the power source.
20. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
21. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 45).
Six-bay LFF drive cage
To install a six-bay, LFF hot-plug drive cage in a server, a SAS controller option is required.
To obtain the SAS controller option, contact an authorized HP reseller.
To install the SAS controller option, see the documentation that ships with SAS controller option kit.
To Next Page
Loading...
