HP ProLiant ML350p - Page 95

Hardware options installation 95
13.
Fully install the SFF drive cage, and then secure it by tightening the T-15 screws.
14. Install the fan cage.
15. Install the air baffle.
16. For tower models, do the following:
a. Install the access panel (on page 23).
b. Return the server to an upright position.
17. For rack models, do the following:
a. Install the rack bezel (on page 22).
b. Install the access panel (on page 23).
c. Slide the server back into the rack.
18. Connect each power cord to the server.
19. Connect each power cord to the power source.
20. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
21. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 45).
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1. Installing the Trusted Platform Module board.
2. Retaining the recovery key/password (on page 98).
3. Enabling the Trusted Platform Module (on page 98).