Removal and replacement procedures 43
4.
Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27).
5. Remove the access panel ("Access panel" on page 28).
6. Remove the air baffle ("Air baffle" on page 29).
7. Open the PCI retainer latch.
8. Remove the expansion board.
NOTE: If removing an expansion board from slots 3, 6 or 8, first release the retaining lever on
the system board and then remove the card from the system.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
