Removal and replacement procedures 47
7.
Disconnect the capacitor pack cable from the cache module.
8. Remove the cache module.
To replace the component, reverse the removal procedure.
FBWC capacitor pack
CAUTION: To prevent a server malfunction or damage to the equipment, do not add or remove
the battery pack while an array capacity expansion, RAID level migration, or stripe size migration
is in progress.
CAUTION: After the server is powered down, wait for 30 seconds and then check the amber LED
before disconnecting the cable from the cache module. If the amber LED flashes after 30 seconds,
do not disconnect the cable from the cache module. The cache module is backing up data, and
data will be lost if the cable is disconnected while the amber LED is still flashing.
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 26).
To Next Page
Loading...
