Removal and replacement procedures 49
4.
For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel ("Access panel" on page 28).
5. For rack models, do the following:
a. Extend the server from the rack (on page 27).
b. Remove the access panel ("Access panel" on page 28).
c. Release thumbscrews and remove the rack bezel.
6. Disconnect all cables from the drive backplane.
7. Using a T-15 screwdriver, remove the screws that secure the SFF drive cage to the server.
8. Remove the SFF drive cage.
9. Remove all drives from the drive cage ("Drive" on page 35).
To Next Page
Loading...
