Removal and replacement procedures 44
4.
Remove the processor air baffle.
To replace the component, reverse the removal procedure.
Center wall
To remove the component:
1. Power down the server (on page 29).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 29, "Remove the
server from the rack" on page 30).
3. Remove the access panel. ("Access panel" on page 31)
4. Remove the processor air baffle ("Processor air baffle" on page 43).
5. Remove the full-length expansion boards ("Expansion board" on page 41).
6. Lift the center wall retaining latch.
To Next Page
Loading...
