Specifications 91
Specification Value
Power supply output
Rated steady-state power
800 W (low line), 1000 W (high line)
Maximum peak power
1000 W (low line), 1200 W (high line)
* 100 to 127 VAC is required for 10 A; 200 to 240 VAC is required for 6.7 A.
Hot-plug power supply calculations
For hot-plug power supply specifications and calculators to determine electrical and heat loading for the
server, see the HP Power Advisor website (http://www.hp.com/go/hppoweradvisor).
FBDIMM specifications
CAUTION: Be sure to install FBDIMMs in the proper configuration. Refer to the Documentation
CD.
Specification Value
Type
FBDIMM, PC2-5300F, Fully-Buffered DIMMs
Size
512-MB, 1-GB, 2-GB, 4-GB, 8-GB
Width
72 bits
Upgrade
requirement *
FBDIMMs must be installed in pairs within a bank. A
bank must be populated with two FBDIMMs with identical
HP part numbers.
*Use only Registered DDR2 FBDIMMs. Use HP FBDIMMs only.
1.44-MB diskette drive specifications
Specification Value
Height
12.7 mm (0.5 in)
Width
96 mm (3.8 in)
Depth
130 mm (5.1 in)
LEDs (front panel)
Green = Active
Read/write capacity per
diskette
High density
1.44 MB
720 KB
Drives supported
1
Drive height
One-third height
Drive rotation
300 rpm
Transfer rate
High
500 Kb/s
Low
250 Kb/s
Bytes/sector
512
To Next Page
Loading...
