2 Care and maintenance
This section provides information about how to care for and maintain the scanner.
•
Clean the scanner glass
•
Remove and replace the scanner lid
•
Order maintenance and scanner supplies
CAUTION: Avoid placing items that have sharp edges in the scanner. Doing so can
damage the scanner. Before placing an item on the scanner glass, make sure that the
item does not contain wet glue, correction fluid, or other substances that can be
transferred to the glass.
Clean the scanner glass
Cleaning of the scanner glass helps ensure high-quality scans. The amount of care
needed depends upon several factors, including the amount of use and the environment.
You should perform routine cleaning as necessary.
1. Disconnect the USB cable from the scanner.
2. Clean the glass using a soft, lint-free cloth that has been sprayed with a mild glass
cleaner, and dry the glass with a dry, soft, lint-free cloth.
CAUTION: Use only glass cleaner. Avoid abrasives, acetone, benzene, and
carbon tetrachloride, all of which can damage the scanner glass. Avoid
isopropyl alcohol because it can leave streaks on the glass.
Do not spray the glass cleaner directly on the glass. If too much glass cleaner is
applied, the cleaner could run to the edges and damage the scanner.
3. When you have finished, reconnect the USB cable to the scanner.
NOTE: For instructions about how to clean the underside of the scanner glass, visit
www.hp.com/support.
14 Care and maintenance
To Next Page
Loading...