HP Scanjet 3000 User Manual

HP Scanjet 3000 Scanner
4
Connect the USB cable
CAUTION: Be sure you install the HP scanning software before
connecting the scanner to your computer with the USB cable. See
“Install the software” on page 2.
Use the USB cable that came with the scanner to connect the scanner to the
computer. Connect the square end of the cable to the scanner and the rectangular
end of the cable to the computer.
NOTE: HP recommends using a USB port on the back of the
computer for a more reliable connection to the scanner.
Test the installation
CAUTION: Before placing an item in the document feeder, make sure
that the item does not contain wet glue, correction fluid, or other
substances that can be transferred to the interior of the scanner.
Make sure there are no curls, wrinkles, staples, paper clips, or any other
attached material. Sheets should not be stuck together.
1. Place a single page in the document feeder. The page should be faced down,
with the top of the page pointing down.

HP Scanjet 3000 Specifications

General

Scanner Type	Flatbed
Bit Depth	48-bit
Grayscale Levels	256
Scan Size Flatbed (Maximum)	216 x 297 mm
Maximum Document Size	216 x 297 mm
Connectivity, Standard	USB 2.0
Compatibility	Windows XP/Vista/7/8/10
Weight	2.2 kg
Power Consumption	2.5 watts (maximum), 1.5 watts (standby), 0.5 watts (off)
Dimensions	450 x 275 x 40 mm