Scanner setup
3
1. Decide what software to install.
• If you will be using the scanner with document-management and
scanning software that you already own, you only need to install the HP
Scanjet Driver.
• If you do not already have document-management and scanning software,
you can use the software that is shipped with the scanner. Read the
onscreen descriptions of the software during the installation to decide
what software to install. (The software and the number of CDs that are
shipped with the scanner might vary by country/region.)
2. Insert the HP Scanjet Software CD into the computer CD drive. Wait for the
installation dialog box to appear.
3. Click Install Software, and then follow the instructions on the screen.
Set up the hardware
Complete the following tasks in order to set up the scanner hardware and prepare it
for use.
Connect the power supply
The green LED on the power supply case is on when the power supply is functioning
correctly.
1. Connect the power supply to the power supply cable, and then plug the power
supply cable into a power outlet or a surge protector.
2. Check that the green LED on the power supply case is on.
3. If the green LED is on, plug the power supply into the back of the scanner.
To Next Page
Loading...
Need help?
General
