HP Scanjet 5370C Series Scanners - Installing and

Using the Active Transparency Adapter (XPA)

Introduction

The Use Transparency Adapter option lets you scan from the connected Active

Transparency Adapter (XPA) instead of scanning from the scanner bed. See the

following for instructions on how to install the Active XPA, as well as how to scan

general 5x5 inch transparencies and 35-mm slides.

NOTE: When Use Transparency Adapter is checked in the Tools menu, the Active

XPA icon appears in the status bar, but only if the Active XPA is connected.

If the menu item is dimmed, shut down HP Precisionscan Pro, connect the Active XPA

to the back of the scanner, and restart HP Precisionscan Pro.

Installing the Active XPA

Plug the Active XPA connector into the back of the scanner.

Figure 1: Plugging in the Active XPA connector

Scanning general transparencies

1. Place the large template on the scanner bed.

Step 1: Placing the large template on the scanner

2. For scanning general transparencies up to 12.7 x 12.7 centimeters (5 x 5

inches), position the transparency in the large cutout area in the middle of

the template.

Step 2: Positioning the transparency

All manuals and user guides at all-guides.com

all-guides.com

HP Scanjet 5370C Series - Page 4

Other manuals for HP Scanjet 5370C Series