user’s manual
scan from the TMA
17
English
scan negatives
To scan 35 mm negatives use the negative holder that is part of the built-in TMA.
1 Open the scanner lid and remove the TMA cover.
2 Click the S
CAN PICTURE button ( ).
A dialog box appears asking what you are scanning.
3 Select Negatives from a Transparent Materials Adapter (TMA).
Note: Do not click Scan until the negative is loaded and the lid is closed.
4 Remove the negative light-shield from the negative holder. The negative
holder is stored in the slide holder.
5 Slide a negative strip into the negative holder so that the shiny side faces
the scanner glass when the scanner lid is closed.
Note: Negatives are easily damaged. Touch them only on their edges.
6 If you are scanning a negative strip that has fewer than four frames, insert
the negative light-shield into the negative holder until it touches the
negative strip.
remove the TMA cover
remove the negative light-shield
insert a negative strip
scanner03_Usermanual.book Page 17 Friday, March 21, 2003 9:57 AM
To Next Page
Loading...