3. Align the edges of the documents by tapping the bottom of the stack against the table
top. Rotate the stack 90 degrees and repeat.
4. Place the stack in the middle of the input tray. Load the stack face up.
5. Adjust the paper guides to the width of the documents. Take care not to overtighten
the guides, which can restrict paper feeding, but make sure that the paper guides
touch the edges of the documents.
6. Gently push the stack forward to activate the tray sensor.
See also
• “
Document loading tips” on page 7
• “
Automatic document feeder (ADF) problems” on page 36
• “
Start a scan” on page 13
Chapter 1
10 Use the scanner
To Next Page
Loading...