EasyManuals Logo

HP Scanjet N6350 Getting Started Guide

HP Scanjet N6350
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Connect the TMA/ADF cable
Connect the TMA/ADF cable from the lid to the scanner base.
Connect the power supply
1. Plug the cable that is attached to the power supply into the power connector on the
back of the scanner.
2. Plug the small end of the AC cable into the back of the power supply.
3. Plug the other end of the AC cable into a power outlet or surge protector.
4. To turn on the scanner, press the Power button on the scanner control panel.
Connect the Ethernet cable
To connect the scanner to a host computer on an existing network, complete the following
steps.
CAUTION: If you are installing in a Windows environment, do not connect the
scanner to the network until prompted to do so during the software install (see “Install
the software” on page 2).
1. Press the Power button to turn off the scanner.
2. Disconnect the USB cable from the scanner if it is connected.
Chapter 1
4 HP Scanjet N6350

Other manuals for HP Scanjet N6350

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Scanjet N6350 and is the answer not in the manual?

HP Scanjet N6350 Specifications

General IconGeneral
Optical Resolution2400 dpi
ADF Capacity50 sheets
ConnectivityUSB 2.0
Scan Resolution2400 x 2400 dpi
Duplex ScanningYes
Maximum Hardware Resolution2400 x 2400 dpi
Document FeederYes
Supported Operating SystemsWindows, Mac OS
Supported Media TypesPaper (plain, inkjet, photo)
Scanner TypeFlatbed, ADF

Related product manuals