●
Slide the paper guides to fit the width of the document. If there is any gap between the paper guides
and the edges of the documents, the scanned image might be skewed.
NOTE: When loading small documents like checks, place the longest edge parallel to the paper width
guides.
Figure 2-2 Adjust paper guides
Load same-sized documents
NOTE: To scan fragile documents (such as photos or documents on wrinkled or very light paper), place the
document face down on the scanning glass.
Make sure to refer to the section Required guidelines before loading documents, and then follow the
following steps to load same-sized documents in the ADF input tray:
1. Tap the long edge of the pages on a flat surface, then rotate and tap the top edge of the document
pages to align the edges of the document pages.
16 Chapter 2 Use the scanner
To Next Page
Loading...
