2. Use a clean, lint-free cloth moistened with water or spray the glass cleaner on a clean, lint-free cloth,
and then thoroughly clean the atbed scanner glass.
CAUTION: Do not spray the glass cleaner directly on the scanner glass as this might cause permanent
damage.
3. Dry the scanner glass with a dry, soft, lint-free cloth.
NOTE: Make sure to dry the scanner glass completely.
4. Turn on the scanner.
The scanner is now ready to use.
Clean the Automatic Document Feeder scanning strips
●
Introduction
●
Clean the scanning strips
Introduction
Clean both of the scanning strips periodically, including any time a scanned image has streaks.
Clean the scanning strips
To clean the scanning strip components, follow these steps:
1. Press the Power button to turn o the scanner, and then disconnect the USB cable and power supply
from the scanner.
2. Lift up the document feeder.
28 Chapter 3 Care and maintenance
To Next Page
Loading...