14 ENWW
Multiple-sheet printing
Figure 1: Multiple-sheet printing
Multiple-sheet N-Up allows you to print more than one copy of a single job or multiple jobs on
multiple sheets across the belt of either the same or different dimensions, using multiple rows of
sheets until the job is complete. Use the built-in media alignment pins for quick positioning of the
sheets across the printer’s width. Align the left side of each sheet with one of the pins, with a
small space from the right edge of the sheet to the next pin, to allow for variations in sheet
dimensions. Alternatively, if you position the pins with zero clearance between the sheets and
each pin, before each print be sure to raise the pins over the thickness of the sheets; otherwise
the sheets could become skewed.
To enable, select the N-Up Sheet Feed option when loading media and have the number of sheets
you intend to print across the width of the printer in position to be loaded. Sheets must not be
more than 3 inches (7.6 cm) apart from each other. Use the alignment pins if you will be printing
multiple rows.
Figure 2: Multiple-sheet options
To Next Page
Loading...
