ENWW 5
Margins definition
The following illustration defines how negative and positive margins are applied on the printer.
As shown in the image above:
- Overprinting is enabled by setting a negative value for the left/right/top and trailing margin.
- White spaces are enabled by setting a positive value for the left/right/top and trailing margin.
Overprinting procedure
The printer does not alter the job; i.e., enlarge the job or add extra pixels to accomplish
overprinting. The job must be resized prior to sending it through the RIP. For best results follow
the instructions below:
1. Configure printer for Save Only: (Go to Printing > Jobs > Settings > Job Storage Mode)
and select Save Only as show in the image below.
To Next Page
Loading...
