Follow a similar procedure to create matte media profiles; but, in this case, uncheck Shutter Trailing Lamp
for all print modes.
Hardware procedure
1. Select your matte media profile.
2. Load the media at the 0 position.
3. Select the job and print.
4. Select your gloss media profile.
5. Reload the media at the same 0 position.
6. Select the second job and print.
Be careful to use the same width, length, and position every time. And load carefully for proper alignment.
Multi-sheet printing is not recommended; single-sheet printing is preferred for the best alignment between
different loads.
How to print relief texture
This section describes a method that can extend the profitability and versatility of your printer. Its
application is at your own risk.
Only operators technically experienced with the RIP and the printer are recommended to try it. If in doubt,
contact your local printer service provider.
64
Chapter 8 Specialty printing options ENWW
To Next Page
Loading...
