Remove the power button board:
1. Release the ZIF connector (1) to which the power button board cable is attached, and then
disconnect the power button board cable from the system board.
2. Detach the power button board cable (2) from the battery. (The power button board cable is
attached to the battery with double-sided tape.)
3. Detach the power button board (3) from the display assembly. (The power button board is
attached to the display assembly with double-sided tape.)
4.
Remove the power button board.
Reverse this procedure to install the power button board.
Removal and replacement procedures
27
To Next Page
Loading...
