Releasing the HP MultiSeat Thin Client t100 from the Mounting Bracket
Figure C-2 Removing the security clip
1. If there is a lock through the HP MultiSeat Thin Client t100 security clip on the back of the HP
MultiSeat Thin Client t100 , unlock and remove it (1).
2. Remove the screw holding the HP MultiSeat Thin Client t100 security clip (2) and remove the
security clip from the back of the mounting bracket (3).
Figure C-3 Removing the mounting bracket
3. Press the bracket lever away from the HP MultiSeat Thin Client t100 (1) and slide the unit out of
the mounting bracket (2).
10 Appendix C Mounting the HP MultiSeat Thin Client t100 ENWW
To Next Page
Loading...
