4. Click Yes. The HP ThinState Capture tool formats and makes the USB flash drive bootable. HP
ThinState Capture will now reboot the system.
5. After you perform these actions, the HP ThinState Capture tool displays the following screen.
Please follow the on-screen instructions.
You can now use the USB flash drive to deploy the captured image to another HP thin client of the
exact same model and hardware with equal or greater flash size capacity.
The following table lists the supported capture and deploy scenarios:
Capture From:
Deploy To:
t5730
1GB Flash
t5720
512MB Flash
t5720
1GB Flash
t5730 1GB Flash X
t5720 512MB Flash X X
t5720 1GB Flash X
36 Chapter 4 Control Panel extended selections ENWW
To Next Page
Loading...
