Installing Components in the Desktop 2 of 36
HP Web Services Your Vectra Setting Up Using
Warranty and
Support Service
Solving
Problems
Installing
Components
Desktop
Before Starting 1 of 1
WARNING
For your safety, never remove the PC’s cover without
first removing the power cord from the power outlet
and any connection to a telecommunications network.
If a power protection device is fitted to your PC, you
must remove the power cord then wait for a complete
shutdown of your system before removing the cover.
Remove the power protection device cables before any
servicing operation. Always replace the cover before
switching the PC on again.
To avoid electric shock and harm to your eyes by laser
light, do not open the laser module. The laser module
should be serviced by service personnel only. Do not
attempt to make any adjustment to the laser unit. Refer
to the label on the CD-ROM drive for power
requirements and wavelength. This product is a class
1 laser product.
CAUTION
Static electricity can damage electronic components.
Turn all equipment OFF. Don’t let your clothes touch the
accessory.
To equalize the static electricity, rest the accessory bag on
top of the PC while you are removing the accessory from
the bag. Handle the accessory as little as possible and with
care.
To Next Page
Loading...
