Problems
Floppy Drive Test Error 1of2
Have you checked that... How
The drive is correctly configured in the
PC’s Setup program.
!
1 Switch the PC OFF then ON.
2 When the message Press F2 to Enter Setup appears, press the F2
key.
3 Check the floppy disk drive is enabled and that the correct type
is selected.
The floppy drive is working
!
Insert a known working floppy disk and see if it works
!
Run e-DiagTools (refer to page 21).
You are using the latest BIOS for your
PC
!
Download the latest BIOS and instructions for its installation from
HP’s support web site.
To Next Page
Loading...
