5 Installing the IBM Turbo 16/4 Token-Ring ISA Adapter
Microsoft Windows NT 4.0 Workstation
5 Installing the IBM Turbo 16/4 Token-Ring ISA Adapter
Microsoft Windows NT
4.0 Workstation
Connecting to a
Windows NT 3.51 Server
Requirements
• HP Vectra with Windows NT 4.0 Workstation.
• IBM Turbo 16/4 Token Ring ISA adapter and drivers disk version 2.22.
• Driver File: IBMTOK.SYS, version 10.27
• Microsoft Windows NT 4.0 Workstation media.
• Microsoft Windows NT 4.0 Service Pack 4 media.
• Microsoft Windows NT 3.51 Server system that supports NetBEUI,
NWLink IPX/SPX Compatible Transport, and NWLink NetBIOS network
protocols.
Device Configuration
Procedure
1 With the HP Vectra turned off, install the IBM Turbo 16/4 Token Ring ISA
adapter into a PCI slot.
2 Connect network cable media to the IBM Turbo 16/4 Token Ring ISA
adapter.
3 Log onto Windows NT4 Workstation with administrator privileges
(Contact your network administrator if you do not have the required
information).
4 Right-click on the “Network Neighborhood” icon and select “Properties”.
5 Click on “Yes” when prompted to install Windows NT Networking.
6 Select “Wired to the network” and click on “Next”.
7 Click on the “Select from list…” button and then the “Have Disk…”
button.
Device Configuration Vectra Vli8
Interrupt 10
I/O Address 300
To Next Page
Loading...
