hp vectra xe310 series 2 pc
1-8 hp vectra xe310 series 2 pc microtower vectras
1
system board jumpers
BIOS history
For the latest BIOS, the flasher utility program, and the BIOS history refer to the
HP’s Web site.
beep codes for hp vectra xe310 series 2
Jumper Function Default
J27
CLEAR Clears CMOS (to reload the Setup program defaults)
NORMAL
NORMAL Normal operation
J29
CLEAR Clears User and Administrator passwords
NORMAL
NORMAL Normal operation
http://www.hp.com/go/vectrasupport/
Beep Pattern Beep Code Numeric
Code
Description
— - - - - - - - 1-2-2-3 16h BIOS ROM check-sum failure
— - - - — — 1-3-1-1 20h DRAM refresh test failure
— - - - — - - - 1-3-1-3 22h 8042 Keyboard controller test failure
— - - - - - - — 1-3-3-1 2Ch Autosize DRAM failure (RAM
module missing or not installed
correctly)
— --- ---- — 1-3-4-1 2Ch RAM failure on address line xxxx
1
1. If the BIOS detects error 2C or 2E (base 512K RAM error), it displays an additional word-
bitmap (xxxx) indicating the address line or bits that failed. For example, “2C 0002” means
address line 1 (bit one set) has failed. “2E 1020” means data bits 12 and 5 (bits 12 and 5 set)
have failed in the lower 16 bits.
— --- ---- --- 1-3-4-3 2Eh RAM failure on data bits xxxx
1
of
low byte of memory bus
— ---- — — 1-4-1-1 30h RAM failure on data bits xxxx
1
of
high byte of memory bus
- - — - - - - - 2-1-2-3 46h ROM copyright notice check failure
- - - - - - - — 2-2-3-1 58h Unexpected interrupts test failure
— - - 1-2 98h Video configuration failure or option
ROMs check-sum failure
- 1 B4h This does not indicate an error.
There is one short beep before
system startup.
xe310-shc.book Page 8 Monday, January 28, 2002 11:36 AM
To Next Page
Loading...
