Installing Accessories
Chassis Beam Assembly
Chapter 2 23
Installing the Chassis Beam Assembly
To install the chassis beam assembly:
1. Hook the chassis beam assembly to the left side of the chassis and
rotate it down over the MEC and the graphics card making sure the
MEC and graphics card retainer clips are centered on the cards as
shown in Figure 2-6 and Figure 2-7.
CAUTION Make sure the retaining clips slide easily over the cards, or the clips
may put undue pressure on the card connectors.
2. Replace the screw that holds the chassis beam assembly in place.
Figure 2-6 MEC Retainer Clip
Retaining clip
on MEC.
To Next Page
Loading...
