HP Xw4400 - Workstation - 2 GB RAM

To Next Page

Creative Sound Blaster X-Fi

Quick Start Guide

This document describes the hardware and software installation of the Creative Sound Blaster X-Fi. For

more information, refer to the Installation and Application CD.

Package Contents

System Requirements

■ HP Workstation xw series (except xw3100)

■ Microsoft Windows XP Service Pack 1 (SP1) or newer operating system

■ Optical drive

■ Empty PCI slot

Warranty Information

Any warranty information is superseded by the HP warranty term provided in the warranty document.

Installing the Card and Software

To install the X-Fi card:

1. Turn off your computer and unplug the AC power cable.

2. Open the chassis and remove the rear PCI metal slot cover where you plan to install the sound card.

3. Disconnect the front audio cable from the front audio header on the system board.

If your system came with a CD audio cable that connects the optical drive to the system board,

disconnect the cable from the system board end only and leave the optical drive end conneted.

■ Sound Blaster X-Fi audio card

■ Front audio adapter cable (for HP Workstation

xw6 or xw8 series systems, see the system

requirements section)

■ Cable clip

■ Support arm

■ Installation and Application CD

■ Regulatory compliance notices

■ Warranty information

Other manuals for HP Xw4400 - Workstation - 2 GB RAM

Need help?

Do you have a question about the HP Xw4400 - Workstation - 2 GB RAM and is the answer not in the manual?

General