Installing Accessories
Memory Expander Card (MEC)
Chapter 2 25
Memory Expander Card (MEC)
Removing the MEC
To remove the MEC:
1. Turn off the display and shut down the Workstation. Disconnect all
power cables and any LAN or telecommunications cables.
2. Remove the Workstation’s cover (see page 15).
3. To ease installation, place the Workstation on its side with the system
board facing upwards.
4. Rotate the hard disk drive cage to the open position (see page 19).
5. Remove the chassis beam assembly (see page 22).
6. Remove retaining screw that holds the MEC in place and gently
remove the MEC from the chassis as shown in Figure 2-8.
CAUTION You must remove the MEC to install RIMMs. The MEC card guides
are not strong enough to bear the force of the RIMMs being inserted.
To Next Page
Loading...
