Setting Up and Using Your Linux Workstation
Setting Hardware Passwords in the HP Setup Program
Chapter 1 21
If You Forget Your User Password
1. Switch off the Workstation.
2. Re-start the Workstation. If you are prompted for a password, enter
the Administration password.
3. When Press F2 to Enter Setup appears, press the F2 key.
4. Enter the Administrator password to access the Setup program.
5. Go to the Security menu.
6. Go to the Set User Password field and set a new User Password. This
will replace the old password which you had forgotten.
7. Press Esc or select Exit Menu to save the new password. and exit
Setup.
To Next Page
Loading...
